206 MEMORY CHANNELSINFORMATION CHANNELS10 Information channels are available for storingradio broadcasting service frequencies, such asweather radio stations and community FMbroadcasting stations. For your conveniences,pressing [INFO] instantly recalls the Informationchannel to B-band. The following frequency data isstored by default.rebmuNlennahC emaNyromeM/edoM/ycneuqerFA6F-HT E7F-HT1–I /MF/zHM055.261REHTAEW)ytpmE(atadoN2–I /MF/zHM004.261REHTAEW3–I /MF/zHM574.261REHTAEW4–I /MF/zHM524.261REHTAEW5–I /MF/zHM054.261REHTAEW6–I /MF/zHM005.261REHTAEW7–I /MF/zHM525.261REHTAEW8–I /MF/zHM056.161REHTAEW9–I /MF/zHM577.161REHTAEW0–I /MF/zHM572.361REHTAEWYou can revise the default channel data, such as thereceiving frequencies, modes, and memory names.RECALLING AN INFORMATION CHANNELPress [INFO] to recall the Information channels.• “I–n” appears, where “n” represents theInformation channel number from “0” ~ “9”.• If the B-band is selected for operation, you canturn the Tuning control or press [ ]/ [ ] to selectother Information channels. If the A-band isselected for operation, press [A/B] to move theoperation band to the B-band and then select adifferent Information channel.• To exit the Information channel mode, press [A/B]to select the B-band then press [VFO] or [MR].Note: If you press [MN<->f], you can display the receiving frequencyin place of the memory name.TH-F7E only: As default, no frequency data is stored in theInformation channel. Store the frequency data before using theInformation channels. Otherwise, an error beep sounds.REPROGRAMMING THE INFORMATION CHANNEL1 Press [VFO].2 Select a desired frequency and mode.3 Press [F].4 Turn the Tuning control or press [ ]/ [ ] to selectthe memory channel (I–0 to I–9) in which you wantto store the data.5 Press [MR] ([ ] or [MNU]).• A long beep sounds and the Informationchannel data is now revised.Note:uWhen you perform the Full reset {page 50}, all the Informationchannels recover the factory default values.uIf you clear an Information Channel data {page 16}, the factorydefault value is recovered.uYou can also transfer the Information Channel data to the VFOor another memory channel.