1PREPARATIONINSTALLING THE Li-ion BATTERY PACKNote: Because the battery pack is provided uncharged, you mustcharge the battery pack before using it with the transceiver. Tocharge the battery pack, refer to “CHARGING THE Li-ion BATTERYPACK” {page 2}.1 Position the two grooves on the edge and twohooks at the bottom of the battery pack over thecorresponding guides on the back of thetransceiver.2 Slide the battery pack along the back of thetransceiver until the release latch on the top of thetransceiver locks the battery pack in place.3 To remove the battery pack, push the release latchon top, then slide the battery pack down.INSTALLING ALKALINE BATTERIES1 To open the battery case (BT-13), push the lockingtab in, then pull the cover back.2 Insert (or remove) four AA (LR6) alkaline batteries.• Be sure to match the battery polarities withthose marked in the bottom of the battery case.3 Align the two tabs on the battery case cover, thenclose the cover until the locking tabs click.4 To install the battery case onto (or remove it from)the transceiver, follow steps 1 to 3 of“INSTALLING THE Li-ion BATTERY PACK”{above}.Note: When you use the alkaline batteries, access Menu No. 30(BATTERY), then select “ALKALINE”. Otherwise, the batteryremaining cannot be measured correctly {page 36}.INSTALLING THE ANTENNAHold the base of the supplied antenna, then screwthe antenna into the connector on the top panel of thetransceiver until secure.aATTACHING THE HAND STRAPIf desired, you can attach the supplied hand strap tothe transceiver.INSTALLING THE BELT CLIPYou can install the supplied belt clip to the transceivertightening the 2 supplied screws.TabScrewsStrapTabsGroovesLatch