Kenwood TK-3173 Instruction Manual

Also see for TK-2170 SERIES: Service manual Function reference Instruction manual Specifications Service manual

10I NSTALLING THE C AP OVER THE SPEAKER / MICROPHONE JACKSInstall the cap over the speaker/ microphone jacks when notusing an optional speaker/ microphone.1 Insert the speaker/ microphone plugs into thespeaker/ microphone jacks of the transceiver.2 Place the locking bracket over the speaker/microphone plugs so that the locking tabsinsert into the transceiver grooves.3 While holding the locking bracket in place,push it towards the bottom of the transceiveruntil the tabs on the bracket click into place.Note:◆ When not using an optional speaker/ microphone,install the cap over the speaker/ microphone jacks.◆ The transceiver is not fully water resistant whenusing a speaker/ microphone or headset.ï To remove the locking bracket, push the bracket upfrom the base.1 Place the cap over the jacks so that the lockingtabs insert into the transceiver grooves.2 While holding the cap in place, push it towardsthe bottom of the transceiver until the tabs onthe cap click into place.Note: To keep the transceiver water resistant, you mustcover the speaker/ microphone jacks with the supplied cap.ï To remove the cap, hold the top of the cap in placewith your finger while inserting a 3 mm or smaller flatblade screwdriver under the bottom of the cap.Slowly slide the screwdriver in until its tip touches thetab inside the cap, then gently pry the cap up (handleof screwdriver moving away from the transceiver) toremove the cap.I NSTALLING THE (OPTIONAL ) S PEAKER / MICROPHONE