TK-52107REALIGNMENT● Self programming mode flow chart9. Firmware Information Mode(K2 and K3 models only)Turn the transceiver ON with the [Side3] key held down.Then, the version is displayed during holding the [Side3] key.10.Clock Adjustment Mode(K2 and K3 models only)10-1. Flow chart of operation[Orange] + [PTT] + Power ON Release [Orange]MINUTEHOURDAYMONTHYEAR[A][A][A][A][A][Side2] and [Side3] keys or [C] and [D] keys[Side2] and [Side3] keys or [C] and [D] keys[Side2] and [Side3] keys or [C] and [D] keys[Side2] and [Side3] keys or [C] and [D] keys[Side2] and [Side3] keys or [C] and [D] keysCompletionTX NAC[A]RX NAC[A]TX signaling[A][A]RX signaling[A][A] [A][A]*1*2[A]TX frequencyRX frequency[A] When the [Side3] key is pressed, new data is written into memory.[A]Zone/Channel[A]Read authorization password entry (6 digits)[A][Side2] + [PTT] + POWER ON Release [PTT][TX frequency] : Other than "OFF"[Channel type] : "MIXED"[TX frequency] : Other than "OFF"[Channel type] : "ANALOG" or "MIXED"[TX mode] : "ANALOG"[TX frequency] : "OFF"[TX frequency] : Other than "OFF"[Channel type] : "APCO" or "MIXED"If [Channel type] is set to "MIXED", [TX mode] must be set to "APCO".[Channel type] : "ANALOG" or "MIXED"[A][Channel type] : "APCO"[TX frequency] : "OFF"[Channel type] : "ANALOG" or "APCO"[TX frequency] : "OFF"[Channel type] : "APCO" or "MIXED"[A][TX frequency] : "OFF"[Channel type] : "ANALOG"[A][Channel type] : "ANALOG"[A]Talkgroup ID List Amount : 0[Channel type] : "APCO" or "MIXED"[Channel type] : "APCO" or "MIXED"Talkgroup ID List Amount must not be 0.Self programming modeInput PasswordOFF QTOFFZone selectionAPCOChannel selectionTalkgroup list number[A][A][A][Side 3][B]DQT N[B][B]DQT I[B][B] [B] [B][B]ANALOGChannel type[C]/[D]APCOANALOGTX mode[C]/[D]Channel spacing 12.5kHz25.0kHz[C]/[D]12.5kHz*1 [Channel type] : "ANALOG" or "MIXED"*2 [Channel type] : "APCO"APCO 12.5kHz[C]/[D][C]/[D]MIXED[C]/[D]OFF QT DQT N[B]DQT I