10CONVENTIONAL SCANIf the Scan function is programmed, Conventional zones or channels can bescanned by pressing the key programmed as Scan. Scan can be used as eitherSingle Scan or Multi Scan.• Single Scan monitors only the channels of the currently selected zone, which havebeen added to the scanning sequence. If set up to scan Priority channels, the Prioritychannels will be scanned even if they are not within the currently selected zone.• Multi Scan monitors all channels of every zone, which have been added to the scanningsequence.To activate Scan, press the key programmed as Scan.• The icon and “ ” or the revert zone and channel number appear on the display.• The zone add indicator ( ) will appear on the display when the selectedzone is added to the scan sequence. The channel add indicator ( ) willappear on the display when the selected channel is added to the scan sequence.• When a call is received, scanning stops and the zone and channel digits appear. Pressthe microphone PTT switch and speak into the microphone to respond to the call. Thetransceiver will continue scanning after a predetermined time delay if the PTT switch isreleased and no further signal is received.To stop scanning, press the Scan key again.ADD TO SCAN/ DELETE FROM SCANPress the key programmed as Scan Delete/Add to add or remove each channelto or from the scan sequence.• The channel add indicator ( ) will appear on the display when the selectedchannel is added to the scan sequence.Press the key programmed as Zone Delete/Add to add or remove each zone toor from the scan sequence.• The zone add indicator ( ) will appear on the display when the selectedzone is added to the scan sequence.