TK-7360/7360H/7360H ( V )111. Disassembly Procedure1. When removing the cabinet, first remove the two screwsfrom the right and left with a phillips screwdriver.Then, hook your finger on the edge of the cabinet andpull it out until it is over the chassis protrusion. Removethe cabinet by prying the cabinet as shown below.Cabinet2. To remove the panel assembly, first turn the transceiverupside down.Then, insert a flat-head screwdriver into the holes of thechassis and tilt it in the direction as shown by the arrow.Panel assemblyHoles3. Disconnect the flat cable from connector of the panel as-sembly.Flat cable4. Hook the finger to hole and while pulling the speakerholder to this side, expand the panel side of q to e, andremove the speaker holder from the front panel.Speaker holder@:.5. When removing the TX-RX PCB, first remove the toppacking.Then, remove the solder of the antenna hot pin and posi-tive terminal of the DC cord.Remove the 15 screws from the TX-RX PCB, powermodule, and audio amp.Positive terminalof the DC cord Antenna hot pinPower moduleTop packingTX-RX PCBAudio ampDISASSEMBLY FOR REPAIR