Kenwood TK-7360 Service Manual

Also see for TK-7360: Instruction manual Brochure & specs Specifications Instruction manual Instruction manual

Contents

TK-7360/7360H/7360H ( V )8■ Installation Procedure: Method A1. Remove the two screws on both the right and left sidesof the transceiver, then remove the cabinet and top pack-ing from the transceiver.2. Remove the chip resistor R863 (4.7kΩ) on the TX-RXunit.TX-RX unitComponent sideR8633. Cut the crimp terminal side of the KCT-18 using a pair ofnippers or similar tool.Cut4. Solder the cable side cut in the above step 3 to the “IGN”pad on the TX-RX unit.TX-RX unitComponent sideIGN5. Dress the KCT-18 cable as shown in the figure. The KCT-18 cable needs to pass through one of two indentationslocated on the rear panel of the transceiver.KCT-18Indentation part6. Cut off the projection of the top packing using a pair ofnippers or similar tool.If the KCT-18 cable is dressed to be routed through theindentations on the right side in step 5, the right side ofthe projection needs to be cut off. If the KCT-18 cable isdressed to be routed through the indentations on the leftside, the left side of the projection needs to be cut off.Following is a figure presenting an example for when theright side of the projection is cut off.7. Reinstall the top packing. Check the correct fitting of thetop packing, then reinstall the cabinet and two screwsfor the right and left sides.8. Connect the other side of the KCT-18 to the ignition lineof the car.■ Installation Procedure: Method B1. Remove the two screws on both the right and left sidesof the transceiver, then remove the cabinet and top pack-ing from the transceiver.2. Remove the chip resistor R863 (4.7kΩ) on the TX-RXunit.TX-RX unitComponent sideR8633. Remove the ACC. cap on the rear of the transceiver.4. Connect the D-sub connector of the KCT-60 to the D-sub15-pin terminal of the transceiver.5. Insert the crimp terminal side of the KCT-18 to pin 2 ofthe square plug.6. Connect the square plug to the 15-pin connector of theKCT-60.7. Connect the other side of the KCT-18 to the ignition lineof the car.Note: You must set up using the KPG-135D(K) or KPG-135D(M).INSTALLATION