Kenwood TK-7360 Service Manual

Also see for TK-7360: Instruction manual Brochure & specs Specifications Instruction manual Instruction manual

Contents

TK-7360/7360H/7360H ( V )4Merchandise receivedLicense and frequency allocated by FCC: K type onlyChoose the type of transceiverTransceiver programmingKCT-60Connection cableKCT-36Extension cableKES-5External speakerKCT-18Ignition sense cableKES-3External speakerVGS-1Voice guide &storage unitSee page 4.A personal computer, programming interface (KPG-46/46A),and FPU (programming software) are required for programming.Frequency range (MHz) RF power Type136~174136~17450W50W TK-7360H K,M136~174 25W TK-7360 M,M2TK-7360H(V) K(Option)(Option)(Option)(Option)(Option)(Option)DeliverySee page 9.See page 9.See page 7. See page 9.See page 6.SYSTEM SET-UP1. ModesUser modePC mode PC programming modePC test mode PC tuning modePanel test mode Panel tuning modeClone modeFirmware version informationMode FunctionUser mode For normal use.Panel test mode Use by the dealer to check the fundamentalcharacteristics.Panel tuning mode Used by the dealer to tune the transceiver.PC mode Used for communication between the trans-ceiver and PC.PC programmingmodeUsed to read and write frequency data andother features to and from the transceiver.PC test mode Used to check the transceiver using the PC.This feature is included in the FPU.PC tuning mode Used to tune the transceiver using the PC.Clone mode Used to transfer programming data from onetransceiver to another.Firmware versioninformationUsed to confi rm the internal fi rmware ver-sion.REALIGNMENT2. How to Enter Each ModeMode OperationUser mode Power ONPanel test mode [ ]+Power ONPanel tuning mode Panel test mode+[ ]PC mode Received commands from PCClone mode [ ]+Power ON (One second)Firmware version information [ ]+Power ON3. Panel Test ModeSetting method refer to ADJUSTMENT.4. Panel Tuning ModeSetting method refer to ADJUSTMENT.5. PC Mode5-1. PrefaceThe transceiver is programmed using a personal com-puter, a programming interface (KPG-46/46A, USB adapter(KCT-53U)) and FPU (programming software).The programming software can be used with a PC. Fig-ure 1 shows the setup of a PC for programming.