Kenwood TK-7360 Service Manual

Also see for TK-7360: Instruction manual Brochure & specs Specifications Instruction manual Instruction manual

Contents

TK-7360/7360H/7360H ( V )66-1. Adding the data passwordIf the read authorization password is set in the optionalfeature menu, you must enter the password (Source trans-ceiver) to activate a clone mode.You can use 0~9 to configure the password. The maxi-mum length of the password is 6 digits.1. [ ]+Power ON.2. “CLONE LOCK” is displayed on the LCD.3. If the [ ] and [ ] keys is pressed while “CLONE LOCK”is displayed, numbers (0 to 9) are displayed flashing.When you press the [ ] key, the currently selectednumber is determined. If you press the [ ] key after en-tering the password in this procedure, “CLONE MODE”is displayed if the entered password is correct. If thepassword is incorrect, “CLONE LOCK” is redisplayed.Cloning cable(E30-3382-05)Fig. 26-2. Flow chart (Source transceiver)Press [ ] key + Power ON for 1 secondIspassword*set?* ReadAuthorizationpasswordShows CLONE LOCKYesYes[ ]NoNoClone modeEnter passwordStart the clone funnctionIs enteredpasswordcorrect?7. Firmware Version InformationPress and hold the [ ] key while turning the transceiverpower ON and then keep pressing and holding the [ ] key,the fi rmware version information appears on the LCD.INSTALLATIONREALIGNMENT1. Connection Cable (KCT-60: Option)The KCT-60 connection cable kit is used to connect thetransceiver to a Horn alert cable, KCT-18 (Ignition sensecable), KES-5 (External speaker), or through the KCT-36 ex-tension cable.1-1. Installing the KCT-60 (Connection cable) in thetransceiver1. Remove the ACC. cap on the rear of the transceiver.2. Connect the D-sub connector of the KCT-60 to the D-sub15-pin terminal of the transceiver.3. Connect the 15-pin connector of the KCT-60 to a Hornalert cable, KCT-18, KES-5, or through a KCT-36 extensioncable.Note: You must setup using the KPG-135D(K) or KPG-135D(M).Horn alert cable,KCT-18, KES-5 or throughKCT-36 extension cableKCT-60