Kenwood TK-7360 Service Manual
Also see for TK-7360: Instruction manualBrochure & specsSpecificationsInstruction manualInstruction manual
                                                                 | |
TK-7360/7360H/7360H ( V )37ADJUSTMENTCommon SectionItemCondition Measurement Adjustment Specifications /RemarksPanel tuning mode PC test mode Test-equipment Unit Terminal Unit Parts Method1. Setting 1) Power supply voltageDC power supply terminal: 13.6V2) SSG standard modulation[Wide] MOD: 1kHz, DEV: 3kHz[Narrow] MOD: 1kHz, DEV: 1.5kHz2. ReceiveAssistVoltage(Automatic)1) Adj item: [RXASS]Adjust: [∗∗∗∗]2) TEST CH: Low,Low’, Center, High’,High (5 points)3) Press [ ] key tostore the adjust-ment value.1) (Auto tuning)* PowermeterFPU “Voltage Level”indicator on PC win-dow shows VCOlock voltage.Change the adjust-ment value to getVCO lock voltagewithin the limit ofthe specifi ed volt-age.Note:Confi rm the VCOlock voltage ap-proximately 3seconds after theadjustment value ischanged.2.5V±0.2V3. TransmitAssistVoltage(Automatic)1) Adj item: [TXASS]Adjust: [∗∗∗∗]2) TEST CH: Low,Low’, Center, High’,High (5 points)3) PTT: ON4) Press [ ] key tostore the adjust-ment value.1) (Auto tuning)*2) Transmit4. VCO LockVoltageCheck• RX1) Adj item: [RXASS]Adjust: [∗∗∗∗]2) TEST CH: Low,Low’, Center, High’,High (5 points)1) TEST CH: Low,Low’, Center, High’,High (5 points)PowermeterDVMTX-RX LV Check 2.5V±0.2V• TX 3) Adj item: [TXASS]Adjust: [∗∗∗∗]4) TEST CH: Low,Low’, Center, High’,High (5 points)5) Transmit2) TEST CH: Low,Low’, Center, High’,High (5 points)3) Transmit*: At test mode, click [Tune Assist Voltage] button in test mode dialog box, then start automatic adjustment of Receive/Transmit assist voltage.Transmitter SectionItemCondition Measurement Adjustment Specifications /RemarksPanel tuning mode PC test mode Test-equipment Unit Terminal Unit Parts Method1. Frequency 1) Adj item: [FREQ]Adjust: [∗∗∗]2) PTT: ON3) Press [ ] key tostore the adjust-ment value.1) TEST CH: TX center2) TransmitFrequencycounterANT [Paneltuningmode][ ],[ ][PC testmode]FPUAdjust to centerfrequencyWithin ±100Hz2. High Trans-mit Power• TK-73601) Adj item: [HPOW]Adjust: [∗∗∗∗]2) TEST CH: Low,Low’, Center, High’,High (5 points)3) PTT: ON4) Press [ ] key tostore the adjust-ment value.1) TEST CH: Low,Low’, Center, High’,High (5 points)2) TransmitPowermeterAmmeter25W ±1.0W8.0A or less• TK-7360H/7360H(V)50W ±2.0W14.0A or less |
Related manuals for Kenwood TK-7360
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine