PROGRAM SCANThis type of scan is similar to VFO Scan except theprogrammable aspect allows you to set scan limits to limitthe frequency range of the scan.m@ Setting Scan Limits1 Press [F]+ POWER ON to access Menu B.2 Select “PGM.SCN” {page 17}.3 Press [VFO].¢ “LO” and the current lower limit appears. The defaultis the currently selected frequency.(lamvame f4(Toe 2 |MHz tid (Ss*:*=C i]4 Turn the Tuning control, or press microphone[UPY[DWN], to display the desired lower limit.¢ Press [MHz] if you want to change the frequency in1 MHz steps.5 Press [VFO].e “UP” and the current upper limit appears. The defaultis the currently selected frequency.6TurntheTuningcontrol,orpressmicrophone{UP}[DWN],todisplaythedesiredupperlimit.* Press [MHz] if you want to change the frequency in1 MHz steps.7 Press [VFO] to set the upper limit.8 Press [F] or microphone [PTT] to exit Menu B.Note:@ = The fower limit must be lower in frequency than the upper limit.@ The lower and upper frequency steps must be equal.@ Selections must be made within approximately 10 seconds or theprevious mode is restored.Confirming Scan Limits1 Press [F]+ POWER ON to access Menu B.2 Select “PGM.SCN” {page 17}.3 Press [VFO].¢ This is the lower limit.4 Press [VFO] again.« This is the upper limit.5 Press [F] or microphone [PTT] to exit Menu B.
