Kenwood TS-711A Instruction Manual

Also see for TS-711A: Instruction manual Service manual Instruction manual Instruction manual Service manual

@ DIGITAL FUNCTION@ MemoryThere are 40 memory channels.M1: Frequency; 144.000 MHz, Mode;AUTO CW, and Dial; click are the de-fault values.M2 ~ M35: Ordinal memory channels.M36 ~ M38: Split memory channels, i.e., transmitand receive frequencies can be storedindividually.M39 ~ M40: The program scan range is stored inthese two channels.@ Memory contentsFrequency, mode, main dial status (click or continuouslyvariable), offset, and tone can be stored in each memorychannel RIT status cannot be stored.@ Memory entryM. IN CH. S VFO/M1. In VFO mode, select the data to be memorized with themain dial.2. Set the CHS switch to ON and select the desired me-mory channel.3. Press the M.IN switch, and 8 beeps will sound.Press the M.IN switch again while the beeps are sound-ing. When memory entry has been performed, the beepsounds again to verify memory storage.4. Channels M36 through M38, require input of bothtransmit and receive frequencies.After the RX frequency has been entered the radio willemit a series of 4 beeps.Select the desired transmit frequency and then pressthe M.IN key. A single beep will sound to confirm entry.< COM>M. IN COM1. Inthe VFO mode, set the data to be memorized with themain dial.2. Press the M.IN switch and a double beep will sound andrepeat. Press the COM switch while the beep is sound-ing. A single beep will confirm entry. data replacement>M. IN VFO/MRecall the desired M.CH with the VFO/M switch. If thestored data except frequency fails, reset the required data.Press the M.IN switch and beep will sound. Press the M.INswitch again while the beep is sounding and the replaceddata is stored.@ SCANThe scan modes of this transceiver are:Program scan in VFO; memory scan in M.CH; and modescan in M.CH.@ Program scan1. In VFO A or B, when the SCAN switch is set to ON,scan will start within the limits stored in M39 and M40.When VFO is at a point, scan starts as follows.aLower limit 4145.0 Upper limitM39When VFO is at b point, scan starts as follows.bLower limit 145.0 Upper limitLower limit 145.0iDown scan* The indicated range is not scanned.15