Kenwood TS-711A Instruction Manual

Also see for TS-711A: Instruction manual Service manual Instruction manual Instruction manual Service manual

~~ FUNCTION=Fe]@ [A=B)] Used to equalize all data (frequency, mode, RITsetting, OFFSET, AL, T and SPLIT).@ |MPV! Switches all data from memory channel to VFO.Also, switches from COM channel to VFO.Main dial control@ In VFO mode: Used to set frequency.@ In M.CH mode: Used to select memory channel from01 through 40 by click type rotation.@ In CS mode: Used to select digital code channel fromCO through C9 by click type rotation.@ In TONE SEL mode: Used to select subtone frequency01 (67 Hz) through 37 (250.3 Hz) by clicktype rotation.* For the TS-711A only@ When the main dial is in continuous tune mode, rapidlyrotating the dial will automatically selectthe increased step size.@ MODE/keys (1 ~ 0)FM, USB, CW, LSB: Used to select the desired mode.When pressed, initial letter of mode is an-nounced by morse code thru the speaker.@ [AUTO] Used to switch mode automatically in con-junction with the frequency range selected.The mode change is announced by singlebeep.) Used to activate and stop scan. To stopscan, any of the ten keys can be used. Be-fore initiating scan, the SQL control must beset to the threshold point. The scan willstop at a busy station (busy-scan). Thescan is time-operated (T/O scan), so thatthe scan resumes after an 6 seconds delayat the busy station. In the FM mode, thescan stops at the center frequency. (centerstop function)e (MIN) Used to store data in memory channel.Storable data are: Frequency; mode; dialclick; offset; and tone frequency (TS-711Aonly). (See page 14.)@ |REV & LOCK) Used to lock frequency out of dial andkeyboard operation. However, the RIT cir-cuit can be operated. Pressing the REV &LOCK switch lights the REV & LOCK indica-tor.Memory channels 36, 37 and 38 are forODD SPLIT memory channels. When theREV & LOCK switch is depressed in thesememory channels the Tx and Rx frequen-cies will be reversed.