Kenwood TS-711A Instruction Manual

Also see for TS-711A: Instruction manual Service manual Instruction manual Instruction manual Service manual

CONTROLS,CONNECTORSANDINDICATORSFront Panel (Illustrated is the TS-711A)@ POWER switchTurns the transceiver ON and OFF.® S meterIn receive mode, works as an S (signal) meter. In transmitmode, indicates RF or ALC corresponding to the ALC/RFswitch setting.In SSB/CW mode, indicates S-9 with 50 uV input. Gra-duations of 9 + 20 dB, 9 + 40 dB and 9 + 60 GB are also in-cluded.POWER= as ge 9, 2, 29,80 © @® Frequency and subfunction displaySe * a) Indicates transmit and receive frequency, digital code,ose Gr oes CALL sign (ASCII) and subtone frequency.b) Indicates memory CH number, digital code CH numberand subtone CH number (Not for TS-711E).c)Indicates RITfrequencyshift(-9.9~9.9kHz)andtransmitdigitalcodeCHnumber.d) Normally indicates MHz and kHz. When flashing, indi-cates scan is in operation.e) Lights when in memory CH mode.f) Lights when VFO A or VFO Bis selected.g) Lights when tone is operated.h) Lights when VFOs are operated alternately or SPLITmemory CH is operated.i) Lights (-) when TX OFFSET shifts -600 kHz.Lights (+) when TX OFFSET shifts +600 kHz.j) Lights when Alert operation is set.k) Lights when the RIT switch is set to ON.@® CH.Q switch (Channel QSO abbreviated)When in the VFO mode this switch selects either “channe-lized” (click type) or continuously variable tuning on theMain Dial. When in the M (memory) mode channelizedtuning is always selected.VFO stepMain dialCH.O SoBe rotationFUNCTIONb>] =5)CH.O ON 5 kHz ClickCH.O OFF 10 Hz Through* For units designed for use in European countries.