Kenwood TS-890S Command Reference Manual

Also see for TS-890S: Instruction manual Setting manual In-depth manual Manual Service bulletin

– 43 –PC CONTROLCOMMAND REFERENCE GUIDEMA7 Memory Channel (Temporary Change Frequency) Parameters:P1 (Target frequency for read and answer (Read / response only))0: Frequency on the left side frequency display area1: Frequency on the right side frequency display area (Splitchannel only)P2 (11 digit end frequency in Hz) Blank digits must be entered as “0”. Response while calling an unregistered memory channel, alldigits are space.• This command is used to temporarily change the frequency ofthe currently calling (displaying) channel and read the displayedfrequency in the memory channel mode.• The frequency of this command is the frequency before addingthe RIT/XIT frequency.• In the Programmable VFO, it can be set the registeredfrequency range.• You cannot be set to an empty channel.• This command can temporarily change the frequencyregardless of the setting state of the menu [4-01] “TemporaryChange (Memory Channel Configurations)”.• When the AI function is ON, the response command isoutputted when switching from the VFO mode to the memorychannel mode or when switching the memory channel.Set1 2 3 4 5 6 7 8 9 10M A 7 P2 P2 P2 P2 P2 P2 P211 12 13 14 15 16 17 18 19 20P2 P2 P2 P2 ;Read1 2 3 4 5 6 7 8 9 10M A 7 P1 ;Answer1 2 3 4 5 6 7 8 9 10M A 7 P1 P2 P2 P2 P2 P2 P211 12 13 14 15 16 17 18 19 20P2 P2 P2 P2 P2 ;ME0 Pop-up Message 1 Parameters:P1 (3-digit message ID)Refer to the Message ID table belowP2 (Operations on Messages)0: Functions as the [ESC] key1: Functions as the [F1] key2: Functions as the [F2] key3: Functions as the [F3] key4: Functions as the [F4] key5: Functions as the [F5] key6: Functions as the [F6] key7: Functions as the [F7] keyP3 (Key Operation)0: Functions as a key press1: Functions as a long key press (Valid on screens withlong pressed key only)2: Functions as a key release (used when releasing [F-REC]during the voice message recording screen)• Operation of the F key which is specified with the settingcommand for P2 differs every message. [?;] is not respondedeven when pressing the F key to which no function is assigned.Set1 2 3 4 5 6 7 8 9 10M E 0 P1 P1 P1 P2 P3 ;Read1 2 3 4 5 6 7 8 9 10M E 0 ;Answer1 2 3 4 5 6 7 8 9 10M E 0 P1 P1 P1 ;