Kenwood TS-890S Command Reference Manual

Also see for TS-890S: Instruction manual Setting manual In-depth manual Manual Service bulletin

– 4 –PC CONTROLCOMMAND REFERENCE GUIDEAN Antenna Selection Parameters:P1 (Antenna selection)1: ANT12: ANT29: No change (setting command only)P2 (Receiving antenna usage state)0: RX ANT is not used1: RX ANT is used9: No change (setting command only)P3 (Drive out selection)0: Drive out OFF1: Drive out ON9: No change (setting command only)P4 (Antenna output for external receiver)0: Antenna output OFF1: Antenna output ON9: No change• When setting the command, enter only the parameters you arechanging. For parameters you are not changing, enter “9”.• For a response command, parameter P1~ P4 cannot be “9”.Set1 2 3 4 5 6 7 8 9 10A N P1 P2 P3 P4 ;Read1 2 3 4 5 6 7 8 9 10A N ;Answer1 2 3 4 5 6 7 8 9 10A N P1 P2 P3 P4 ;AP0 Audio Peak Filter ON/OFF Parameters:P11: APF OFF2: APF ONSet1 2 3 4 5 6 7 8 9 10A P 0 P1 ;Read1 2 3 4 5 6 7 8 9 10A P 0 ;Answer1 2 3 4 5 6 7 8 9 10A P 0 P1 ;AP1 Audio Peak Filter Shift Parameters:P100 ~ 8099: Initial value setting (center) (setting command only) 40 is the center (CW pitch frequency). 00 represents a –200 Hz shift from center. 80 represents a +200 Hz shift from center. Each step represents a 5 Hz shift.Set1 2 3 4 5 6 7 8 9 10A P 1 P1 P1 ;Read1 2 3 4 5 6 7 8 9 10A P 1 ;Answer1 2 3 4 5 6 7 8 9 10A P 1 P1 P1 ;AP2 Audio Peak Filter Pass Bandwidth Parameters:P10: NAR1: MID2: WIDE9: Initial value setting (setting command only)Set1 2 3 4 5 6 7 8 9 10A P 2 P1 ;Read1 2 3 4 5 6 7 8 9 10A P 2 ;Answer1 2 3 4 5 6 7 8 9 10A P 2 P1 ;AP3 Audio Peak Filter Gain Parameters:P10 ~ 69: Initial value setting (setting command only)Set1 2 3 4 5 6 7 8 9 10A P 3 P1 ;Read1 2 3 4 5 6 7 8 9 10A P 3 P1 ;Answer1 2 3 4 5 6 7 8 9 10A P 3 P1 ;