Kenwood TS-890S Command Reference Manual

Also see for TS-890S: Instruction manual Setting manual In-depth manual Manual Service bulletin

– 57 –PC CONTROLCOMMAND REFERENCE GUIDERF RIT/XIT Frequency Parameters:P1 (RIT/XIT frequency direction)0: + direction1: – directionP2 (RIT/XIT frequency in Hz)0000 ~ 9999Read1 2 3 4 5 6 7 8 9 10R F ;Answer1 2 3 4 5 6 7 8 9 10R F P1 P2 P2 P2 P2 ;RG RF Gain Parameters:P1000 ~ 255Set1 2 3 4 5 6 7 8 9 10R G P1 P1 P1 ;Read1 2 3 4 5 6 7 8 9 10R G ;Answer1 2 3 4 5 6 7 8 9 10R G P1 P1 P1 ;RL1 Noise Reduction 1 Level Parameters:P101 ~ 1099: Initial value setting (setting command only)Set1 2 3 4 5 6 7 8 9 10R L 1 P1 P1 ;Read1 2 3 4 5 6 7 8 9 10R L 1 ;Answer1 2 3 4 5 6 7 8 9 10R L 1 P1 P1 ;」RL2 Noise Reduction 2 Time Constant Parameters:P100 (2 ms) ~ 09 (20 ms)99: Initial value setting (setting command only)Set1 2 3 4 5 6 7 8 9 10R L 2 P1 P1 ;Read1 2 3 4 5 6 7 8 9 10R L 2 ;Answer1 2 3 4 5 6 7 8 9 10R L 2 P1 P1 ;RM Meter Parameters:P1 (Meter type)1: ALC2: SWR3: COMP4: ID5: VD6: TEMPP2 (Read setting)0: Do not read1: Read When turning the power ON, all meters are reset to “do notread”.P3 (Meter oscillation)0000 ~ 0070 This value shows the oscillation (number of dots) of thetransceiver digital meter.• The meter value of the meter type (multiple settings arepossible at the same time) set for read is output with responsecommand.• You can set the type of meter to be displayed using the MTcommand.• The ALC meter value is output during recording and standby(Even when P2 set to “do not read”).Set1 2 3 4 5 6 7 8 9 10R M P1 P2 ;Read1 2 3 4 5 6 7 8 9 10R M ;Answer1 2 3 4 5 6 7 8 9 10R M P1 P3 P3 P3 P3 ;