14 EN1 Strip coating. 2 Push the lever.3 Insert the cord. 4 Return the lever.Setting up the systemConnecting the terminalsSpeaker impedanceAfter confirming the speaker impedance indications printed on therear panel of the receiver, connect speakers with matching impedanceratings. Using speakers with a rated impedance other than thatindicated on the rear panel of the receiver could result in malfunctionsor damage to the speakers or receiver.• Never short circuit the + and – speaker cords.• If the left and right speakers are connected inversely or the speakercords are connected with reversed polarity, the sound will beunnatural with ambiguous acoustic imaging. Be sure to connect thespeakers correctly.Connecting the antennasAM loop antennaThe supplied loop antenna is for use indoors. Place it as far as possiblefrom the receiver, TV set, speaker cords and power cord, and adjustthe direction for best reception.FM indoor antennaThe supplied indoor antenna is for temporary use only. For stablesignal reception we recommend using an outdoor antenna. Disconnectthe indoor antenna when you connect one outdoors.FM outdoor antennaLead the 75Ω coaxial cable connected to the FM outdoor antenna intothe room and connect it to the FM 75Ω terminal.Use anantennaadapter(Commerciallyavailable)Attach to thestandAM loop antennaFM indoor antennaFM outdoor antennaAM antenna terminal connections1 Push lever. 2 Insert cord. 3 Release lever.FM antenna terminal connectionsInsert cord.+-+-GNDAM FM75ΩANTENNA