18 ENListening to a source component1Use the INPUT SELECTOR knob or keys to select the sourceyou want to listen to.The input sources change as shown below:1 “AUX”2 “TUNER”3 “CD/DVD”4 “TAPE” or “MD”5 “VIDEO1”6 “VIDEO2”7 “DVD/6CH”2Start playback from the selected source.3Use the VOLUME CONTROL knob or VOL +/– keys to adjust thevolume.Normal playbackSome preparatory steps are needed before starting playback.Turning on the receiver1 Turn on the power to the related components.2 Turn on the power to this receiver by pressing POWER ON/STANDBY key.Selecting the input modeIf you have selected a component connected to the CD/DVD, VIDEO 2or DVD/6CH jacks, make sure that the input mode setting is correct forthe type of audio signal to be used. 8Selecting MD/TAPESelect the source name corresponding to the component connected tothe MD/TAPE jacks. The initial factory setting is “TAPE”. To change thesource to “MD”, follow the steps below:1 Use the INPUT SELECTOR knob to select “TAPE”.2 Hold down the AUTO key for more than 2 seconds.• The source indication changes to “MD”.• To return to the original indication, repeat procedure 2.Setting the speaker statusPress the SPEAKERS ON/OFF key to switch the speakers on or off.Preparing for playbackThe speaker indicator lights up.4¢ + ++INPUT SELECTORVOLUME CONTROLInputSelectorVOLINPUT SELECTORPOWERON/STANDBYSPEAKERSON/OFFAUTO