Kenwood VR-8070 Instruction Manual

Also see for VR-8070: Service manual

48 ENFor your recordsRecord the serial number, found on the back of the unit, in the spacesdesignated on the warranty card, and in the space provided below. Referto the model and serial numbers whenever you call upon your dealer forinformation or service on this product.Model __________________ Serial Number ________________________Notes1. KENWOOD follows a policy of continuous advancements in development. For this reason specifications may be changed without notice.2. The full performance may not be exhibited in an extremely cold location (under a water-freezing temperature).SpecificationsAUDIO sectionRated power output during STEREO operationEffective power output during SURROUND operationFRONT (20 ~ 20 kHz, 0.09 % T.H.D. at 8 Ω one channel driven)............................................................................... 100 W + 100 WCENTER (20 ~ 20 kHz, 0.09 % T.H.D. at 8 Ω one channeldriven) .................................................................................. 100 WSURROUND (20 ~ 20 kHz, 0.7 % T.H.D. at 8 Ω one channeldriven) ................................................................... 100 W + 100 WSURROUND BACK (20 ~ 20 kHz, 0.7 % T.H.D. at 8 Ω onechannel driven) .................................................... 100 W + 100 WTotal harmonic distortion ....................... 0.009 % (1 kHz, 50 W, 8 Ω)Frequency responseLine (CD/DVD, TAPE, VIDEO 1, VIDEO 2, VIDEO 3, DVD/6CH)................................................. 10 Hz ~ 100 kHz, +0 dB ~ –3.0 dBPHONO ‘RIAA’ response .............. 40 Hz ~ 20 kHz, +1.5 dB ~ –3.0 dBMaximum input levelPHONO (MM) .................................... 40 mV, 1 % T.H.D. at 1 kHzSignal to noise ratio (IHF’66)PHONO (MM) ........................................................................ 75 dBLine (CD/DVD, TAPE, VIDEO 1, VIDEO 2, VIDEO 3, DVD/6CH)............................................................................................... 95 dBLoudness controlVOLUME at –30 dB level ...................................... +6 dB (100 Hz)Input sensitivity / impedancePHONO (MM) ........................................................... 4 mV / 47 kΩLine (CD/DVD, TAPE, VIDEO 1, VIDEO 2, VIDEO 3, DVD/6CH).............................................................................. 300 mV / 47 kΩOutput level / impedanceTAPE REC ............................................................... 300 mV / 1 kΩPRE OUT (FRONT CHANNEL) ................................... 1 V / 500 ΩPRE OUT (CENTER CHANNEL) ................................. 1 V / 500 ΩPRE OUT (SURROUND CHANNEL) .......................... 1 V / 500 ΩPRE OUT (SURROUND BACK CHANNEL) ............... 1 V / 500 ΩPRE OUT (SUBWOOFER) .......................................... 1 V / 500 ΩTone controlBASS ................................................................ ±10 dB (at 100 Hz)TREBLE ............................................................ ±10 dB (at 10 kHz)DIGITAL AUDIO sectionSampling frequency ...................... 32 kHz, 44.1 kHz, 48 kHz, 96 kHzInput level / impedance / wave lengthOptical .............................. –15 dBm ~ –24 dBm, 660 nm ±30 nmCoaxial ................................................................... 0.5 Vp-p / 75 ΩOutput level / impedance / wave lengthOptical .............................. –21 dBm ~ –15 dBm, 660 nm ±30 nm100 watts per channel minimum RMS, both channels driven,at 8 Ω from 20 Hz to 20 kHz with no more than 0.09% totalharmonic distortion. (FTC)VIDEO sectionVIDEO inputs / outputsVIDEO (composite) .................................................. 1 Vp-p / 75 ΩS VIDEO inputs /outputsS VIDEO (luminance signal) ................................... 1 Vp-p / 75 ΩS VIDEO (chrominance signal) ....................... 0.286 Vp-p / 75 ΩCOMPONENT VIDEO inputs /outputsCOMPONENT VIDEO (luminance signal) .............. 1 Vp-p / 75 ΩCOMPONENT VIDEO (CB/CR-signal) ................. 0.7 Vp-p / 75 ΩFM tuner sectionTuning frequency range ................................. 87.5 MHz ~ 108.0 MHzUsable sensitivity (MONO) ............................................................................................. 1.3 μV (75 Ω)/ 13.2 dBf (75 kHz dev, SINAD 30 dB)50 dB quieting sensitivitySTEREO .............................. 28 μV (75 Ω)/ 40.2 dBf (75 kHz dev)Total harmonic distortionMONO (1 kHz, 75 kHz dev) .......................... 0.5% (65 dBf input)STEREO (1 kHz, 67.5 + 67.5 kHz dev) ......... 0.7% (65 dBf input)Signal to noise ratioMONO (1 kHz, 75 kHz dev) ........................ 75 dB (65 dBf input)STEREO (1 kHz, 67.5 + 67.5 kHz dev) ....... 68 dB (65 dBf input)Stereo separation (1 kHz) ........................................................... 40 dBSelectivity (±400 kHz) ................................................................. 70 dBFrequency response (30 Hz ~ 15 kHz) .................... +0.5 dB, –3.0 dBAM tuner sectionTuning frequency range10 kHz step .................................................. 530 kHz ~ 1,700 kHzUsable sensitivity (30% mod, S/N 20 dB) .......................................................................................................................... 16 μV / (600 μV/m)Signal to noise ratio (30% mod, 400 Hz) .............................................................................................................. 50 dB (60 dBμV EMF input)GENERALPower consumption ................................................................... 3.4 AStandby Power consumption ...................................... less than 1 WAC outletSWITCHED ......................................... (total 150 W, 1.25 A max.)Dimensions ..................................................... W : 440 mm (17-5/16")H : 159 mm (6-1/4")D : 392 mm (15-7/16")Weight (Net) ............................................................ 11.7 kg (25.8 lb)Caution : Read this page carefully to ensure safeoperation.

/ 48

Related manuals for Kenwood VR-8070