Kenwood XD-6000 Instruction Manual

Also see for XD-6000: Instruction manual Instruction manual

Contents

Kenwood XD-6000 Instruction Manual Manual pdf 33 page image

XD-8550/XD-6000 (En/T)3 3Preparation sectionBasic sectionApplication sectionKnowledge sectionsSelection of DOLBY NR (Noise Reduction)The Dolby NR system minimizes the hiss noise heard whenplaying tape.To end recordingSelection of the reverse mode÷ Pressing the key pauses recording after leaving a non-recordedspace of about 4 seconds.÷ If the key is pressed again in less than 4 seconds after it has beenpressed, recording resumes from that instant.÷ Recording can also be stopped by pressing the stop (7) key.However, the non-recorded section is not left in this case.1 Start recording.2 Play (or tune) the input source to berecorded.4. Select the source to be recorded.5. Start recording.÷ When the CD input is selected and if a dischas been set in the CD player, its playbackstarts immediately. Press the stop (7) key tostop the playback.Let's recordSelect an input source other than “TAPE”.÷ Recording stops automatically when the tapeside(s) to be recorded have been fully re-corded.LightsREC / ARM172To let recording pause temporarily (Pause)÷ Press the REC/ARM key to resume recording.8PAUSELightsREV.MODEDOLBY NREach press switches the modes as follows.1 “DOLBY NR indicator” ON........ DOLBY NR is used.2 “DOLBY NR indicator” OFF........ DOLBY NR is not used.Each press switches the modes as follows.1 “[” ... Both sides are recorded, and then the tapestops (If direction 2 is selected, only theback side of tape will be recorded.).2 “”” .. Both sides are recorded (If direction 2 isselected, only the back side of tape will berecorded.).3 ““” .. Only one side is played back (recorded),and then the tape stops.REV.MODEDOLBY NRLights up(when CD input is selected)NoteNoteIf you want to use one of “Convenientrecording functions”, make preparationuntil this stage. pAUX MD TAPE TUNER CD44Select the input source to be recorded.REC / ARM55UNER CDWhen the recorded sound level is too low or too high causingdistortion, it is possible to adjust the recording level manually.›