Kenwood XD-6000 Instruction Manual

Also see for XD-6000: Instruction manual Instruction manual

Contents

Kenwood XD-6000 Instruction Manual Manual pdf 70 page image

XD-8550/XD-6000 (En/T)7 0Preparation sectionBasic sectionApplication sectionKnowledge sections÷ Adjust the present time again.÷ Adjust the present time again.÷ Adjust the present time referring to “Clockadjustment”.÷ Set the timer ON time and OFF time.÷ Execute the timer program with the SRS3D key.÷ Connect antennas.÷ Select a band.÷ Tune to the frequency of the desired sta-tion.÷ Install the outdoor antenna in an apart posi-tion from the road.÷ Switch the suspected electric applianceOFF.÷ Install the TV or the system at an increaseddistance between them.÷ Preset stations with tunable frequencies.÷ Preset stations again.÷ This is not malfunction. Press the DEMOkey to cancel the demonstration.÷ Cancel the AUTO POWER SAVE function.÷ Please consult your nearest KENWOODservice station.÷ There was a power failure.÷ The power cord was unplugged from theoutlet.÷ The present time has not been adjusted orthere was a power failure.÷ The timer ON time and OFF time have notbeen set.÷ The timer execution was not set up.÷ The antennas have not been connected.÷ A proper broadcasting band has not beenselected.÷ The frequency of the station to be receivedis not tuned.÷ Car ignition noise.÷ Influence of an electric appliance.÷ A TV set is installed near the system.÷ The frequency of the preset station is nottunable.÷ The preset memory has been cleared be-cause the power cord has been unpluggedfor a long period.÷ The power plug was unplugged from theoutlet while the power switch was ON, orthere was a power failure.÷ The AUTO POWER SAVE function is acti-vated.÷ There is a certain trouble. The displayedfigure is variable depending on the details ofthe trouble.The clock display blinks without chang-ing the figures.Timer operation is not possible.Radio stations cannot be received.Noise interferes.A station has been preset but it cannotbe received by pressing the P.CALL key.Demonstration starts suddenly.Power is turned OFF suddenly.An error message is displayed(ERROR * (figure))In case of difficultyRemedyCauseSymptomTuner/Equalizer Unit‰‰Á¨6ºº⁄⁄P¡What seems to be a malfunction is not always so. Before calling for service, check the following table according to thesymptom of your trouble.Operation to resetThe microcomputer may fall into malfunction (impossibility tooperate, erroneous display, etc.) when the power cord is un-plugged while power is ON or due to an external factor. In thiscase, execute the following procedure to reset the microcom-puter and return it to normal condition.÷ Please note that resetting the microcomputer clears the contentsstored in and returns and to condition when it left the factory.While holding the ENTER key depressed, unplug the powercord and plug it again.ENTERC-H6 or C-H5