Kenwood XD-951 Instruction Manual

Also see for XD-951: Instruction manual Instruction manual

Contents

Kenwood XD-951 Instruction Manual Manual pdf 28 page image

XD-951/A900/A700 (En)28Preparation sectionBasic sectionApplication sectionKnowledge sectionsLet’s record1 Press the play key corresponding tothe desired direction.2 Stop playback (by pressing the &key).To reverse the transport directionWhen the equalizer or SRS 3D is applied to the sound, the sound with the applied effect can be recorded . iWhen Dolby Pro Logic, Dolby 3 Stereo or DSP mode is selected, cancel it by pressing the STEREO key of the remote controlunit.Note that this cassette deck cannot record onto Metal tapes.NoteNote÷ When recording is started, the tape is trans-ported in the direction selected in this step.÷ Wind the tape to the position where recordingis to be started.Check the tape transport directionindicator.Transport directionRecording (Deck B only)1. Load a tape in deck B.1 Open the door of deck B.2 Insert a tape.3 Close the door.2. Select the tape transport direction.3. Set the recording condition.1Select the reverse mode.2Select the DOLBY NR mode.22113344550PUSHOPEN11A32 722REV.MODE DOLBY NR33NRB0000EPAT÷ Differentiation between normal (TYPE ) andhigh (TYPE ) tape is set automatically.÷ Remove tape slack before loading.(Except for some areas)÷ When the microphone is not used, set the MICVOL. control knob fully counterclockwise tothe minimum position.