Kenwood XD-951 Instruction Manual

Also see for XD-951: Instruction manual Instruction manual

Contents

Kenwood XD-951 Instruction Manual Manual pdf 29 page image

XD-951/A900/A700 (En)29Preparation sectionApplication sectionKnowledge sectionsBasic sectionSelection of DOLBY NR (Noise Reduction)To pause recordingSelection of the reverse mode÷ Pressing the key pauses recording after leaving a non-recorded spaceof about 4 seconds.÷ If the key is pressed again in less than 4 seconds after it has beenpressed, recording resumes from that instant.1 Play (or tune) the input source to berecorded.2 Start recording.4. Select the source to be recorded.5. Start recording.÷ When the CD input is selected and if a disc hasbeen set in the CD player, its playback startsimmediately.The Dolby NR system minimizes the hiss noise heard whenplaying tape. When playing a tape prerecorded with DolbyNR ON, be sure to set the DOLBY NR ON for playback.Lit when “DOLBY NR” is ON.Each press switches the modes as follows.1 “[” ... Both sides are played back (recorded), andthen the tape stops.2 “”” .. Both sides are played back endlessly.(The tape stops after recording onto bothsides.)3 ““” .. Only one side is played back (recorded),and then the tape stops.Each press switches the modes as follows.1 “Ÿ NR” ON ............... DOLBY NR is used.2 “Ÿ NR” OFF ............. DOLBY NR is not used.Let's recordSelect an input source other than “TAPE”.÷ Recording stops automatically when the tapeside(s) to be recorded have been fully recorded.The input source component to be recorded should be displayed.LightsREC/ARMINPUT 44NRB0EPAT31 210000DC1 TUNER (Radio)2 CD3 TAPE4 AUX (External input)(AUX INPUT LEVEL adjustment u)DOLBY NRREV.MODEREC/ARM5531 210120DC