232. Installation2.1. Tools Needed• Socket set with 3/8" socket, 1/2" socket, and 9/16" socket• Open end wrenches 14mm and 19mm, or adjustableopen end wrench• Hex wrenches: 4mm, 5mm, 6mm• Cross-tip screwdriver• Razor blade knife2.2. UnpackingUnpacking and installation of the treadmill should be done by aqualified technician. The packaged treadmills are very heavyand weigh as follows:• L7 models: 360 lb, packaged• L8 models: 435 lb, packagedNote: Move the shipping pallet to location where treadmill will beused before unpacking.Note: For L7 treadmills begin with step 1. For L8 treadmills beginwith step 5.1. For L7 treadmills, the 1/2 inch bolts (total 4) that hold thetreadmill to the pallet must be removed.2. Remove the two top center bolts (Figure 2-1).WARNING To avoid injury, use caution when movingand lifting the treadmill during unpackingand assembly.
