Time Search 37Time Search lets you quickly advance the videotape to a posi-tion simply by entering the amount of playback time you wantto skip.In the example below,Time Search is set to 2 hours, 50 min-utes from the present position.1 Insert a videotape.2 Press SETUP. Press ▲ or ▼ to select TIMESEARCH.Then, press ENTER.3 Press ▲ or ▼ until your desired time appearsbeneath TIME SEARCH at the top of thescreen. (Example: 2:50 for 2 hours, 50 minutes)Each press of ▲ or ▼ increases or decreases thelength of time by 10 minutes.To cancel the Time Search at this point, press SETUP.4 Press s or B to rewind or fast forward thetape the length of time you chose.The TV/VCR/DVD will rewind or fast forward thetape the specified amount of time.The time counts down on the screen as the searchprogresses.When 0:00 is reached, the tape will startplaying.Or, to cancel the time search before it finishes, pressSTOP C.TIME SEARCH2 : 50– TV/VCR SETUP –TIMER PROGRAMMINGSETTING CLOCKCHANNEL SET UPUSER'S SET UPV-CHIP SET UPLANGUAGE [ENGLISH]CAPTION [OFF]ZERO RETURNTIME SEARCHINDEX SEARCHB• A Time Search can be set up to amaximum of 9 hours 50 minutesin 10-minute increments.• Time Search will not operate dur-ing recording.Helpful Hints1 Insert a videotape.PLAYSTOPENTERRECORD DISCMENURETURNTITLESETUPA-BREPEATSEARCH MODECLEARMODE ANGLESUBTITLEAUDIODISPLAYSPEED C.RESETSTANDBY-ON PICTURE SELECTSLEEPCH.VOL.MUTEZOOM1 2 34 5 67 8 90 +10+100REPEAT2-42T0006UG_6006UG_EN_1.qx3 04.5.12 10:09 AM Page 37
