1 NoticeMAGNAVOX and SMART. VERY SMART. are registered trademarks ofKoninklijke Philips N.V. and are used under license from KoninklijkePhilips N.V.Funai reserves the right to change products at any time without beingobliged to adjust earlier supplies accordingly.The material in this Owner’s manual is believed adequate for the intendeduse of the system. If the product or its individual modules or proceduresare used for purposes other than those specified herein, confirmation oftheir validity and suitability must be obtained. Funai warrants that thematerial itself does not infringe any United States patents. No furtherwarranty is expressed or implied.Funai cannot be held responsible neither for any errors in the content ofthis document nor for any problems as a result of the content in thisdocument. Errors reported to Funai will be adapted and published on theFunai support website as soon as possible.Pixel characteristicsThis LCD product has a high number of color pixels. Although it haseffective pixels of 99.999% or more, black dots or bright points of light(red, green or blue) may appear constantly on the screen. This is astructural property of the display (within common industry standards) andis not a malfunction.WarrantyNo components are user serviceable. Do not open or remove covers tothe inside of the product. Repairs may only be done by service centersand official repair shops. Failure to do so shall void any warranty, statedor implied.Any operation expressly prohibited in this Owner’s manual, anyadjustments or assembly procedures not recommended or authorized inthis Owner’s manual shall void the warranty.Federal communications commission noticeThis equipment has been tested and found to comply with the limits for aClass B digital device, pursuant to part 15 of the FCC Rules. These limitsare designed to provide reasonable protection against harmfulinterference in a residential installation. This equipment generates, usesand can radiate radio frequency energy and, if not installed and used inaccordance with the instructions, may cause harmful interference to radiocommunications. However, there is no guarantee that interference will notoccur in a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined byturning the equipment off and on, the user is encouraged to try to correctthe interference by one or more of the following measures:● Reorient or relocate the receiving antenna.● Increase the separation between the equipment and the receiver.● Connect the equipment into an outlet on a circuit different from that towhich the receiver is connected.● Consult the dealer or an experienced radio or television technician forhelp.Declaration of conformityTrade name : MAGNAVOXResponsible party : FUNAI CORPORATION, Inc.Model : 50MV349R, 43MV349R, 32MV319RAddress : 21061 S. Western Ave. Suite 210,Torrance, CA 90501, USA*Telephone number : 1 866 341 3738* This is not the mailing address for Open Source Software or Customerservice.ModificationsThis apparatus may generate or use radio frequency energy. Changes ormodifications to this apparatus may cause harmful interference.Any modifications to the apparatus must be approved by Funai.The user could lose the authority to operate this apparatus if anunauthorized change or modification is made.CablesConnections to this device must be made with shielded cables withmetallic RFI / EMI connector hoods to maintain compliance with FCCRules and regulations.Canadian noticeCAN ICES-3 (B) / NMB-3 (B)Analog and digital television receiving apparatus, Canada BETS-7 /NTMR-7.The following FCC/IC RSS applies to the wireless LANadapter included in this product.FCC caution: Any changes or modifications not expressly approved bythe party responsible for compliance could void the user’s authorityto operate this equipment.This transmitter must not be co-located or operated in conjunctionwith any other antenna or transmitter.For product available in the USA market, only channel 1~11 can beoperated. Selection of other channels is not possible.FCC/IC RF Exposure ComplianceThis equipment complies with FCC/IC radiation exposure limits setforth for an uncontrolled environment and meets the FCC radiofrequency (RF) Exposure Guidelines and RSS-102 of the IC radiofrequency (RF) Exposure rules.This equipment should be installed and operated keeping the radiatorat least 20cm or more away from your body.This device complies with Part 15 of FCC Rules and IndustryCanada licence-exempt RSS standard(s). Operation is subject tothe following two conditions: (1) this device may not causeinterference, and (2) this device must accept any interference,including interference that may cause undesired operation of thisdevice.5150-5250 MHz band is restricted to indoor operations only.High-power radars are allocated as primary users (i.e. priorityusers) of the bands 5250-5350 MHz and 5650-5850 MHz and thatthese radars could cause interference and/or damage to LE-LANdevices.Compliance with IC requirement RSS-210 A9.4.4Data transmission is always initiated by software, which is thepassed down through the MAC, through the digital and analogbaseband, and finally to the RF chip. Several special packets areinitiated by the MAC. These are the only ways the digital basebandportion will turn on the RF transmitter, which it then turns off at theend of the packet. Therefore, the transmitter will be on only whileone of the aforementioned packets is being transmitted. In otherwords, this device automatically discontinue transmission in caseof either absence of information to transmit or operational failure.6 .English