22 ENGLISH321► 1. Triangular rule 2. Grip 3. Guide fenceMake sure that the pointer points to 0° on the miterscale. If the pointer does not point to 0°, loosen thescrew which secures the pointer and adjust the pointerso that it will point to 0°.12 3► 1. Screw 2. Miter scale 3. PointerBevel angle0° bevel anglePush the carriage toward the guide fence and tightentwo clamp screws to secure the carriage. Lower thehandle fully and lock it in the lowered position by push-ing in the stopper pin. Loosen the lever at the rear ofthe tool.Turn the 0° bevel angle adjusting bolt (lower bolt) on theright side of the arm two or three revolutions counter-clockwise to tilt the blade to the right.21543► 1. Lever 2. Arm holder 3. 0° degree bevel angleadjusting bolt 4. Arm 5. Release buttonCarefully square the side of the blade with the topsurface of the turn base using the triangular rule, try-square, etc. by turning the 0° bevel angle adjusting boltclockwise. Then tighten the lever securely.123► 1. Triangular rule 2. Saw blade 3. Top surface ofturn tableMake sure that the pointer on the arm point to 0° on the bevel scaleon the arm holder. If it does not point to 0°, loosen the screw whichsecures the pointer and adjust the pointer so that it will point to 0°.1 2 3► 1. Bevel scale 2. Pointer 3. Screw45° bevel angle1► 1. Left 45° bevel angle adjusting boltAdjust the 45° bevel angle only after performing 0° bevelangle adjustment. To adjust left 45° bevel angle, loosen thelever and tilt the blade to the left fully. Make sure that thepointer on the arm points to 45° on the bevel scale on the armholder. If the pointer does not point to 45°, turn the 45° bevelangle adjusting bolt (upper bolt) on the right side of the armuntil the pointer points to 45°.