Makita LS1019 Instruction Manual

Also see for LS1019: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

27 ENGLISH123► 1. Triangular rule 2. Saw blade 3. Top surface ofturn baseCheck if the side of the blade squares with the turn basesurface once again. Loosen the screw on the pointer.Align the pointer with 0° position in the bevel anglescale and then tighten the screw.45° bevel angleNOTICE: Before adjusting the 45° bevel angle,finish 0° bevel angle adjustment.Loosen the knob and fully tilt the carriage to the sidethat you want to check. Check if the pointer indicatesthe 45° position in the bevel angle scale.If the pointer does not indicate the 45° position, alignit with 45° position by turning the adjusting bolt on theopposite side of the bevel angle scale.12► 1. Left 45° adjusting bolt 2. Right 45° adjusting boltAdjusting the laser line positionFor model LS1019L onlyWARNING: The tool must be plugged in whileadjusting the laser line. Take extra care not to switch onthe tool during adjustment. Accidental start up of the toolmay result in serious personal injury.CAUTION: Never look directly into the laserbeam. Direct eye exposure to the beam could causeserious damage to your eyes.NOTICE: Check the position of laser line regu-larly for accuracy.NOTICE: Beware that impacts to the tool. It maycause the laser line to be misaligned or may causedamage to the laser, shortening its life.NOTICE: Have the tool repaired by a Makita autho-rized service center for any failure on the laser unit.The movable range of laser line is decided by the rangeadjustment screws on both sides. Perform followingprocedures to alter the laser line position.1. Unplug the tool.2. Draw a cutting line on the workpiece and place iton the turn base. At this time, do not secure the work-piece with a vise or similar securing device.3. Lower the handle and align the cutting line withthe saw blade.4. Return the handle to the original position andsecure the workpiece with the vertical vise so that theworkpiece does not move from the position you havedetermined.