![NAD T585 Owner's Manual Manual pdf 9 page image](https://manuals-archive2.s3.amazonaws.com/3921230/90687c6ba2c3a0fdf2db1dc434be87389f.jpg)
IDENTIFICATION OF CONTROLSrear panel11 +12v trigger (on/off auto trigger): When the AUTO TRIGGERswitch is set to ON and the POWER switch at the rear panel also setto ON position, a +12V DC input at +12V TRIGGER IN will power ONthe T 585. At this ON condition, the POWER button in the front panelas well as the corresponding DVD 7 [ON/OFF] keys will be disabledeffectively handling this function to an external controller.When the AUTO TRIGGER switch is set to OFF position, the T 585 ignoresany +12V TRIGGER IN command; the unit can be powered ON/OFFusing the POWER button in the front panel or DVD 7 [ON/OFF] keys(make sure the POWER switch at the rear panel is at ON setting as well).12 +12v trigger in: Accepts 12V DC Trigger output from compatiblecomponents such as power controllers and home automation devices.When the AUTO TRIGGER switch at the rear panel is set to ON, a +12VDC input at +12V TRIGGER IN will power ON the T 585 (make sure thePOWER switch at the rear panel is also set to ON position).All NAD products with +12V TRIGGER OUT feature are fully compatiblewith the T 585’s +12V TRIGGER IN.13 ac power inlet: Connect to the supplied IEC-standard removableAC power cord or a compatible cord.14 power Switch: The POWER switch supplies the master AC mainspower for the T 585. When this switch is at ON position, the T 585 isin standby mode as shown by the amber status condition of the LEDindicator. At this condition, the T 585 can be powered ON by pressingthe POWER button on the front panel or [ON] key of DVD 7 remotecontrol.In combination with +12V TRIGGER (AUTO TRIGGER switch set to ON),this POWER switch must be at ON position for the T 585 to be poweredON via a +12V DC input at +12V TRIGGER IN.If you intend not to use the T 585 for long periods of time, set thePOWER switch to the OFF position.ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ