Getting Started with MAXserver Access Servers0038 109Enabling/Disabling Image and Parameter ProtocolsUse the following command to enable or disable software load imageprotocols and operational parameter protocols:Use this command to specify one or all load protocols to use when the accessserver searches for a software load image file or a parameter file. Youspecify whether the protocol applies to the software load image or theparameter file in the command line.By default, a MAXserver attempts to obtain the software load image usingthe CARD protocol and the parameter file using the NVS protocol. If a cardis not present, or the NVS protocol is disabled, the access server attempts toobtain these files using other protocols in this order: DTFTP, XMOP, MOP,BOOTP, RARP. All of these protocols except DTFTP are enabled by default.If you use the keyword ALL to enable all protocols, you also enable DTFTP.You cannot use DTFTP to load the parameter file except on the Network9000 Access Server 720 which doesn’t have NVS. If you do enable DTFTP,specify the following IP addresses:· The load host· The access server· The gateway router to the load host, if necessaryUse the DEFINE SERVER LOAD IP commands to specify this information.
