Getting Started with MAXserver Access Servers0038 113Retrieving Image Files from HostUse this command to retrieve a load image from a host on the LAN to a flashcard in an access server, either through TFTP or XMOP (use XMOP to getthe image from another NBase-Xyplex unit).GET CARD LOAD FILE [image-name] ADDRESS [ip-address] AREA [area-number][ether-address] AREA[area-number]"image-name" The name of the updated image fileip-address The IP address where the image file is locatedether-address The Ethernet address where the image file is located.area-number The area on the flash card where you want to store the file.ExampleGET CARD LOAD FILE "xpcsrv20.sys" 140.179.255.110 AREA 2Terminating Image File LoadingUse this command to terminate the image loading update that was initiatedwith the GET CARD LOAD FILE command.XYPLEX>> GET CARD STOPDump ProtocolsUse the following command to enable or disable dump protocols:DEFINE SERVER DUMP [RECORD] PROTOCOLPROTOCOL|ALLENABLED|DISABLEDThe [record ] variable specifies the primary, secondary, or tertiaryinitialization record.
