Getting Started with MAXserver Access Servers003826Connect the Power CableYou do not need to set the unit for 115V or 230V operation. The powersupply automatically adapts to the input voltage.A grounded AC power outlet should be located within six feet of the back ofthe unit. You can use a UL-approved, 3-prong extension cord if necessary,provided it has sufficient current and voltage capacity. (The cord must havesufficient capacity for the input power, and AC power must meet the criterialisted in).To connect the power cable, complete these steps:1. Plug the AC line cord (supplied) into the AC power receptacle on the rearof the unit. (See Figure 4 for the location of the power receptacle.)2. Plug the other end of the cord into a grounded 3-prong AC power outlet(or a UL-approved extension cord with sufficient capacity that is pluggedinto a suitable outlet).3. When you apply power, the unit performs a self test of its circuitry andthen proceeds to load its software. When the unit has finished loadingits software, the RUN light flashes slowly and the LAN light flashes asEthernet packets are received. (Figure 6 shows the locations of thelights on the front panel.)
