4-14 Chapter 4: 7401-4xxx Hardware InstallationNote: The printhead lever must be closed for auto-loading tofunction.Removing Paper from the Printer Feed RollsIf paper becomes jammed in the printer feed rolls:1. Unlock the cabinet Keylock.2. Raise the bottom of the Display Module Door until fully open andsupported by the Gas Shock.3. Slide the Keyboard Tray forward until it stops.4. Lift the printhead lever.5. Loosen the two thumb screws and remove the Front Paper GuideCover.6. Remove the paper.Note: You can also feed paper manually using the Form Feed buttonon the Printer Switch and Display Panel. Refer to the “Using the PrinterTest and Display Panel” section for details.Removing Power from the PrinterThe printer has an On/Off switch located on the back of the printerand has a separate Power Supply located under the printer. The PrinterPower Supply is plugged into the bottom connector of the Power Stripinside the terminal cabinet. Use either of the following methods toremove power:• Press the On/Off Switch to the Off position.• Unplug the Printer Power Supply plug from the Power Strip.
