Chapter 6: Operating System Recovery 6-3Updating Procedures1. Apply power to the terminal so the CD-ROM drive can be opened.2. Insert the CD that contains the operating system image.7401 Model Software CD LPINsWin2000 WinXPe WinNT Win987401-21xx, 31xx Not Supported Not Supported D370-0433-0100 D370-0444-0100 *7401-22xx, 25xx,32xx, 35xxD370-0504-0100 D370-0485-0100 D370-0483-0100 D370-0481-0100 *7401-26xx D370-0484-0100 D370-0567-0100 D370-0483-0100 Not Supported7401-45xx D370-0554-0100 Not Supported D370-0553-0100 Not Supported7401-46xx D370-0484-0100 D370-0567-0100 D370-0553-0100 Not SupportedNote: * Support for Windows 98 has been discontinued.3. Boot the terminal.4. Press F2 at the screen prompt to enter the Setup Utility.5. In the Advanced menu, select I/O Device Configuration.6. Verify that LPT 1 Mode is set to ECP.7. Go back to the Advanced menu, select Multiple ROM Menu.8. Set the Parallel CD-ROM Boot to Enabled.9. Exit Setup and Save Changes.As the terminal reboots, you should see a message during bootindicating that the CD-ROM has been recognized:Micro Solutions BACKPACK CD-ROM v0.3. . .Booting from BACKPACK CDStarting MS-DOS10. Follow the DOS screen prompts. After each entry you are asked toconfirm your input. You can use 1 or y for Yes, 2 or n for No.
