Chapter 4: 7401-4xxx Hardware Installation 4-21Installing a 7401-4xxx on the EasyPoint 45PedestalThe 7401-4xxx terminal is shipped with the Table Top Mount attached.Use the following procedure to mount a 7401-4xxx terminal on anEasyPoint 45 Pedestal.1. Unlock the Keylock.2. Open the Display Door.3. Slide the Keyboard Tray forward to access and remove the TableTop Mount screws (2) under the keyboard at the front of theterminal.4. Slide the Remove the Table Top Mount from the bottom of theterminal.5. Attach the Table Top Mount to the top of the pedestal using thefour (4) screws.Note: The EasyPoint 45 pedestal may be secured to the floorbefore mounting the 7401-4xxx terminal onto the pedestal. Two12.7 mm (0.5 in.) holes are provided in the base of the pedestal. Use11 mm or 12 mm (0.375 in. to 0.5 in.) bolts or lag screws to securethe pedestal to the floor.Refer to the NCR EasyPoint 7401 Site Preparation Guide (B005-0000-1255) for floor mounting details.6. Route the AC power cord and network cable (if used) out the holein the bottom of the terminal and through the hole in the Table TopMount.7. Slide the terminal into the Table Top Mount being careful not topinch the cables.8. Secure the terminal to the Table Top Mount using the screws (2)removed in Step 3.
