Programming22-12 : DID Intercept Ring GroupNetworking ◆ 18322-12 : DID Intercept Ring GroupDescriptionFor each DID Translation Table, use Program 22-12 : DID Intercept Ring Group to define thefirst destination group for DID calls.Depending on the entry in Program 22-09-02 and 22-11-04, the incoming calls will route to the firstdestination group by the following:● Vacant number intercept (vacant number means that there is no phone connected, no stationcard installed, or the extension number is not defined in Program 11-02)● Busy intercept● Ring-no-answer interceptIf the destination is '0', the calls will be forwarded to the trunk ring group defined in Program 22-11based on the table assigned to the DID trunk.Note: If Program 22-11-05 and 22-11-06 are set, the priority of transferring will be in this order:Program 22-11-05 ☞ Program 22-11-06 ☞ Program 22-12.For busy and no-answer calls, if the first and third destinations are programmed but the sec-ond destination is not, the incoming call goes to the third destination after the first destina-tion. If the first and second destinations are not defined, but the third destination is, the callgoes directly to the third destination (as defined in Program 22-12).Input DataConditionsNoneFeature Cross Reference● Direct Inward Dialing (DID)Level: Aspire S Aspire M/L/XLIN ï Available. ï Available.ï Applicable to IP and ISDN Networking. ï Applicable to IP and ISDN Networking.Conversion Table Area Number 01-20Item No. Day/Night Mode Incoming Group Number Default01 Aspire S: 1-4Aspire: 1-80 (No Setting)1-8 or 1-100 (Incoming Group)101 (DSPDB Voice Mail)102 (In-Skin/External Voice Mail)103 (Centralized Voice Mail)1
