NEC DT830 Series User Manual
Also see for Univerge SV 9500: User guideReference sheetUser guide
                                                                                                                                                                                                                                                                       | |
Contents
| 
254ADJUSTING HEADSET RINGERTONE VOLUMEYou can adjust the ringer tone volume for a headset inan idle or a busy state.To Adjust the Ringer Tone Volume in IdleStatusSTEP 1: Press the Headset key while in idle status toswitch from headset mode to handset mode,and the Headset key lamp turns off.STEP 2: Receives a call from another line.STEP 3: Press the Up/Down ( ) key while a ringertone is on.For Ringer Tone Volume in Busy StatusIf other lines are accommodated in the telephone as asubline, the ring tone volume of a subline call receivedwhile being in the middle of a call through the headsetwill be lower than usual.HOW TO USE THE WIRELESSHEADSETWhen using Wireless Headset, you can answer a call,conduct a conversation, or disconnect the call withhooking operations. Here explains about the terminaloperation using Wireless Headset.To Answer a CallSTEP 1: Press the Call control button of the WirelessHeadset while the ringing tone is on, and theCall control button lights red. Depending onthe installation phase, you can answer thecall by pressing key instead of Callcontrol button.STEP 2: Press the Call control button to end the call,and the Call control button turns off.Note: To pass a ringer tone through the headset,enable “Headset Ring” from the Settings ofMenu screen. For the details, refer to "Menu ListFor Setting".Note: Ringer tone volume can be adjusted only for awired headset connected to the terminal headsetconnector.Note: Ringer tone volume in busy state cannot bechanged when the ringer tone is set to come fromboth the speaker and the headset. For details,contact the system administrator.Note: When you receive another call during a callthrough the headset, the ringer tone volume forother lines in headset mode can be set to thesame level as the normal two-way call. Fordetails, contact the system administrator.Note: The Call control button of Wireless Headsetmust be programmed in advance. For the pro-gramming of the Call control button, contact thesystem administrator.Note: For details on how to connect a telephone andWireless Headset, see the manual attached tothe Wireless Headset.Answer |
Related manuals for NEC Univerge SV 9500
manualsdatabase
Your AI-powered manual search engine