4-40 Upgrading Your System1. Remove both side panels as described earlier in this chapter.2. Remove top panel as described earlier in this chapter.CAUTIONObserve static precautions3. Install the Processor Retention Module removed from the original system board and configurethe system board jumpers on the new board before you install it.4. If this is a replacement system board, install the Real-Time Clock battery, the Pentium IIProcessor(s) and any DIMMs removed from the original system board. Refer to proceduresfound earlier in this chapter.5. Remove the hard disk drive bay as described earlier in this chapter (if not already completedearlier).6. Remove the removable media drive bay (if not already completed earlier).7. Install the system board into the chassis and secure with the mounting screws.8. Connect the fan cable speaker cable and to the system board.9. Connect the front panel switch and LED cables to the system board.10. Connect the external cables to the I/O connectors.11. Connect the power cables to the system board.12. Connect the interface and controller cables to the system board.13. Install any option boards removed.Note: The option boards must be reinstalled in the same slotswhen you reassemble the system.14. Install the hard disk drive bay and removable media drive bay.15. Install the top cover as described earlier in this chapter.16. Install the side panels as described earlier in this chapter and power on the system.Replacing the Power Supply1. Power off the system and remove the left side panel as described earlier in this chapter.2. Remove the hard disk drive bay as described earlier in this chapter.3. Tag and disconnect power cables connected to the system board.4. Tag and disconnect the power cables connected to all internal peripheral devices.5. Support the bottom of the power supply and remove the four screws that secure the powersupply to the rear panel.
