System Setup Utility B-11Recommended Resource SettingsThe following table shows the recommended RCA system board settings for a samplesystem and provides a place for you to record any changes you make to the settings.SYSTEM GROUP NORMAL SETTINGYOURCONFIGURATIONSystem Identification and Version InformationSSU Configuration File Version Display OnlyMP Spec. Version V 1.4Processor Speed Setting 3.5 X Bus SpeedMEMORY SUBSYSTEM GROUPExtended Memory Options Use BIOS Setup UtilityON-BOARD DISK CONTROLLER GROUPOn-board Floppy Controller EnableOn-board IDE Controller Enable Primary andSecondaryON-BOARD COMMUNICATIONS DEVICE GROUPSerial Port 1 Configuration 3F8h – IRQ4Serial Port 2 Configuration 2F8h – IRQ3Parallel Port Configuration 378h – IRQ7Parallel Port Mode Extended Capabilities, PortDMA 1FLOPPY DRIVES GROUPFloppy Drive A Option 3.5 1.44/1.25 MB DriveFloppy Drive B Option Disabled or not installedIDE DEVICES GROUPIDE 32-Bit I/O EnableKEYBOARD GROUPNumlock OFFKey Click DisableTypematic Speed 30CPSTypematic Delay 500 MS DelaySCSI ROM BIOS GROUPEmbedded SCSI Devices Option ROMScan EnableSystem Resource UsageClicking on the Resource Use button in the Configuration window displays the SystemResource Usage window. This window shows what resources each device is consuming.This information is useful for choosing resources if a conflict occurs. Devices can beorganized according to the resources the user wants to examine using the options in theResource section of the screen.
