Windows Setup 4-5Size of the Partition to be CreatedThe required minimum size of a partition to install the system can be obtained from the followingformula:Size required for installation + paging file size + dump file sizeSize required for installation = 2,900MBPaging file size (recommended) = size of memory mounted* × 1.5Dump file size = size of memory mounted* + 12MBIMPORTANT: The above paging file size is necessary for collecting debug information (memorydump). If a value smaller than the “Recommended” value is set for the initial size ofthe paging file, correct debug information (memory dump) may not be collected. The maximum paging file size is 4095MB in a partition. If 1.5 times the size ofmounted memory is larger than 4095MB, set the size at 4095MB. If the size of mounted memory is larger than 2GB, the maximum size of dump file is“2048MB+12MB.”TIPS: The mounted memory size means the total of memory installed on a single CPUmodule.For example, if memory of 512MB is mounted, the required minimum partition size obtained fromthe above formula is as follows:2900MB + (512MB × 1.5) + (512MB +12MB) = 4192MBTIPS: The minimum partition size you can specify in the ft series setup is 3072MB. Thepartition size must be 3072MB or larger for automatic installation. Therefore the sizesmaller than 3072MB cannot be specified.
