1. Setup ProcedureExpress5800/R320d-E4, R320d-M4 Installation Guide (VMware 5.5)54Chapter 1 Installing OS1.11 Setup after installing ft control software1.11.1 Log ServerVMware ESXi 5.0 or later version does not include a service console. Therefore, this model achieves the syslogreporting by forwarding the logs generated by ESXi to the log server on which NEC ESMPRO Agent is installed.To use ftSys Management Appliance as the log server, no additional steps are required after following the stepsin Chapter 1 (1.11.2 Installing Additional Packages– When ftSys Management Appliance is set as the logserver) and Chapter 2 (1.1 NEC ESMPRO Agent)) of this document, because the log server will beautomatically configured and forwarding the logs generated by the ESXi becomes available.Note To use any other server than ftSys Management Appliance as the log server, you need toprepare a Linux server separately. See Chapter 3 (1. Steps for Configuring the SeparateLog Server) of this manual for how to configure the Linux server.The case of using ftSys Management Appliance as the Log Server.The case of using other Linux server as the Log Server.Forward ESXi logsLANsyslog reportManagement PCLog Serverft ServerLinux OSNEC ESMPRO AgentVMware ESXiVM VMVMftSys Management ApplianceOSOSOSForward ESXi logssyslog reportManagement PCLog Server(ftSys Management Appliance)ft ServerVMware ESXiOSNECESMPROAgentVM VMVMOS OS