1. Setup ProcedureExpress5800/R320d-E4, R320d-M4 Installation Guide (VMware 5.5) 57Chapter 1 Installing OS10. When the message below appears, enter "yes" to restart the system. The ESXi host restarts.A host reboot is required to place these updates into service.Enter 'yes' to reboot now or 'no' to allow a manual reboot later: [yes]11. After making sure that the ESXi host is shutdown, take the ft control software Install DVD out from thedrive.1.11.3 Checking status of ft server1. After the ftSys Management Appliance restarts, check the duplication status. Confirm that the SystemFT LED on the front of the server lights.2. Run the following command to confirm if the system is running normally.# /opt/ft/sbin/ft-verifyThe results list for each of the configuration is output. If all items show [PASS], it indicates that theinstallation has been completed successfully.Output example:ftSys Management Appliance hosted by xxx.xxx.xxx.xxx [PASS]Host is configured with enough memory [PASS]ftSys installed on host [PASS]Host software version matches appliance (5.1.1-233) [PASS]ftSys Management Appliance firewall settings [PASS]ftSys Management Appliance installed on boot volume [PASS]Multiple paths to storage [PASS]Network Configuration [PASS]Host ftSys service started [PASS]Host logs available after reboot [PASS]DNS Configuration [PASS]System FT LED