1. Setup ProcedureExpress5800/R320d-E4, R320d-M4 Installation Guide (VMware 5.5)58Chapter 1 Installing OS1.12 Connecting and Configuring OptionsIf there is any optional PCI board or peripheral equipment to connect to NEC Express5800/ft series, turn offthe power to NEC Express5800/ft series, and connect it according to Chapter 2 (5.7 PCI Card) inMaintenance Guide and the device’s instruction.For how to install and use hard disk drive, see Chapter 2 (2. Disk Operations) in Maintenance Guide.Immediately after the installation completes, network configuration for a port is duplicated. When you changethe network configuration or configure the duplication setting by adding a LAN card, it is necessary toconfigure the settings from vSphere Client.For detailed procedures, refer to the User’s Guide and VMware vSphere documents packaged with this guidefrom the following Website by selecting “Release 5.5”http://www.vmware.com/support/pubs/vsphere-esxi-vcenter-server-pubs.html* The contents of this web site is subject to change or delete without notice.For how to configure the duplicated network, see Chapter 2 (3. Duplex LAN Configuration) in MaintenanceGuide.To have enough time to initialize Fibre Channel disk and Fibre Channel switch and so on, adjust [Server] -[Power On Delay Time] by setting System BIOS configuration Utility.
