NEC Express5800/B120e-h User Manual

Also see for Express5800/B120e-h: Manual Maintenance Guide

Contents

2. BIOS Setup Utility (SETUP)Express5800/B120e-h User's Guide 93Chapter 3 Setup2.4 Cases that Require ConfigurationOnly if a case applies to any of following cases, use the SETUP utility to change a parameter which wasconfigured as factory setting. Other than cases described below, do not change the settings. A list of SETUPparameters and factory settings are described in Chapter 2 (1. System BIOS) in "Maintenance Guide".Category Description To be changed RemarkChange date and time Main → System DateMain → System TimeConfigurable on OSOn/Off NumLock on power ON Boot → Bootup Numlock StateBasicOn/Off the function to displaythe NEC logo during POSTBoot → Quite Boot → Disabled Pressing the key canhide the logo.OptionalboardInstall RAID Controller board Advanced → PCI Configuration → PCISlot n Option ROM → Enabledn is PCI slot number of theRAID ControllerChange the boot order ofdevicesBoot → Boot Option Priorities →Change the boot priorityUse remote power on function(from modem)Advanced → Advanced ChipsetConfiguration → Wake On Ring →EnabledUse remote power on function(from RTC alarm)Advanced → Advanced ChipsetConfiguration → Wake On RTC Alarm→ EnabledBootControl from HW consoleterminalAdvanced → Serial PortConfiguration → Change respectivesetting.Security Set a password Security → Administrator Password→ Enter a password(Set a password for Administrator firstand then User)There are two types ofpassword; Administrator andUser.Settings for User passwordis limited compared to forAdministrator.When the server is suppliedwith power from UPS, alwaysturn on the power.Server → AC-LINK → Power OnIf the server is turned off byusing POWER switch, leave itOFF even when UPS suppliespower.Server → AC-LINK → Last StateUPSPowerlinkKeep the power OFF evenwhen UPS supplies power.Server → AC-LINK → Stay off