3. EXPRESSSCOPE ENGINE 3Express5800/B120e-h User's Guide96Chapter 3 Setup3.2 EXPRESSSCOPE ENGINE 3 Network ConfigurationThe network configuration of management LAN of EXPRESSSCOPE Engine 3 is obtained automatically fromthe Enclosure Manager which has DHCP server function. For detailed information on DHCP server of EM card,refer to EM Card User's Guide or Blade Enclosure User's Guide. By the factory default, DHCP is set toEnabled.If DHCP is set to Disabled and you want to use the management LAN of EXPRESSSCOPE Engine 3, followsteps below to configure the network.1. Run POST following Chapter 3 (1.5.1 POST Execution Flow). Wait until the following messageappears on the lower left of the screen.Press SETUP, Internal flash memory, ROM Utility, Network2. If you press the key at this time, ROM utility starts upon completion of POST.You can also press the key while the NEC logo is being displayed to open the Off-line TOOLMENU screen.3. The keyboard selection screen appears. Select your keyboard type.After that, the Off-line TOOL MENU screen appears. On this screen, specify the network settings forEXPRESSSCOPE Engine 3.
