Installing the Operating System with Express Setup 5-89When the system is Windows Server 2008 R2Follow the procedure below to specify.1. Click Start and select [Control Panel].The [Control Panel] window appears.2. Click [System and Security] and then select [System].NOTE: If [View by] is not set as [Category], start [System] fromControl Panel directly.3. Click [Advanced system settings].The [System Properties] dialog box appears.4. Select [Advanced] tab.5. Click [Settings] on the [Startup and Recovery] group box.6. Modify [Dump file] in the [Write debugging information] group box, and click [OK].e.g. Write the debug information in D drive with the file name"MEMORY.DMP".D:\MEMORY.DMPIMPORTANT: To specify "Complete Memory Dump" to write the debuginformation is recommended. If the mounted memory size is largerthan 2GB, "Complete Memory Dump" cannot be specified so thatspecify "Kernel Memory Dump" instead. Specify the drive where there is a free area more than the size of"the memory capacity mounted on Express server + 300MB". In case the mounted memory size exceeds 2GB due to the addedmemory, change the write debugging information to [KernelMemory Dump] before adding memory.The size of debugging information (memory dump) to be taken alsochanges due to adding memory. Verify the size of the empty spacein the debugging information (memory dump) write destinationdrive.7. Click [Settings] in the [Performance] group box.The [Performance Options] window appears.8. Click [Advanced] tab on the [Performance Options] window.9. Click [Change] on the [Virtual memory] group box.
