7-8 Maintenance6. Select [Test and diagnostics].Select [End-User Mode] and the system diagnostics starts. The diagnostics will becompleted in approximately three minutes. When the diagnostics is completed, the screenof the display changes as shown below:Diagnostics tool title[Enter] Detail Information [ESC] Return to Enduser MenuTest EndTeDoLi (TEst & Diagnosis On Linux) Ver001.00 (Build020901.1.1m)MEM Memory 16 count NormalEndCACHE Cache 49 count NormalEndHDD_02:000 DK32DJ-36W 89 count NormalEndStart 10:06:58 End 10:09:58 Pass 000:03:00 TestTime 000:03:00Test End : NormalEnd 03 AbnormalEnd 00 ForceEnd 00Guide line Test summary windowTest resultTest window title– Diagnostics tool titleShows the name and version of the diagnostic tool.– Test window titleShows the progress of the diagnostics. "Test End" is displayed when the diagnosticscompletes.– Test resultShows the start, end, and elapsed time and completion status of the diagnostics.– Guide lineShows the details of the keys to operate window.– Test summary windowShows the results of each test that executed the diagnostics. Move the cursor andpress the Enter key on the cursor line to display the details of the test.When an error is detected by the system diagnostics, the relevant test result in the Testsummary window is highlighted in red, and "Abnormal End" is displayed in the result onthe right side.Move the cursor to the test that detected the error, and press the Enter key. Record theerror message that has been output to the Detail Information screen and contact yourservice representative.
