Troubleshooting 8-43Problems with NEC EXPRESSBUILDERWhen the server is not booted from the NEC EXPRESSBUILDER DVD-ROM, checkthe following: Did you set the NEC EXPRESSBUILDER during POST and restart the server?→ If you do not set the NEC EXPRESSBUILDER during POST and restart theserver, an error message will appear or the OS will boot. Is BIOS configuration correct?→ The boot device order may be specified with the BIOS SETUP utility of the server.Use the BIOS Setup utility to change the boot device order to boot the systemfrom the optical disk drive first. Is the connected Flash FDD or inserted floppy disk formatted?→ Make sure that the Windows recognizes that the connected Flash FDD or insertedfloppy disk is formatted. If not, format it. If [Os installation ***default***] is selected at Boot selection screen, followingmessage is displayed:→ After this message appears, check the error and take the appropriate correctiveaction according to the message listed in the table below.Message CauseThis EXPRESSBUILDER version was notdesigned for this computer.Insert the correct version and click [OK].(When you click [OK], the computerreboots.)This NEC EXPRESSBUILDERversion is not designed for this server.Execute the NEC EXPRESSBUILDERon the compliant server.EXPRESSBUILDER could not get thehardware parameters written in thismotherboard.This version is not designed for thiscomputer or the motherboard may bebroken. (When you click [OK], the computerreboots.)The hardware parameters written in thismotherboard are incorrect.This version is not designed for thiscomputer or the motherboard may bebroken.This message is shown when NECEXPRESSBUILDER could not findsystem-specific information becauseof mother board exchange and so on.
