7. Resetting and Clearing the ServerExpress5800/T120e Maintenance Guide 45Chapter 1 MaintenanceThe following instructions show how to clear the CMOS memory and the password.WARNINGBe sure to observe the following precautions to use the server safety. Failure toobserve the precautions may cause death or serious injury. For details, refer toSafety precautions in Precautions for Use in "User’s Guide". Do not disassemble, repair, or alter the server. Do not remove lithium, NiMH, or Li-ion batteries. Disconnect the power plug before installing or removing the server.CAUTIONBe sure to observe the following precautions to use the server safely. Failure toobserve the precautions may cause burns, injury, and property damage. Fordetails, refer to Safety precautions in Precautions for Use in "User’s Guide". Make sure to complete installation. Do not get your fingers caught. Avoid installing under extreme temperature conditions.Important Take anti-static measures before operating the server. For detailedinformation on static electricity, refer to Chapter 2 (1.2 Anti-static Measures)in "User's Guide". Clearing CMOS memory1. Turn off the server, and disconnect the AC power cord from power supply units.See "Getting Started" attached to this server or Chapter 2 (1. Installing Internal Optional Devices) in"User’s Guide" to remove Side Cover.2. Confirm the position of Clear CMOS Jumper.3. Change the jumper from Keep to Clear.4. Wait at least five seconds and then return the jumper to Keep.5. Reassemble the server.6. Plug in the power cord and turn on the server.7. Press key to start BIOS Setup Utility, and then run Load Setup Defaults from Save & Exit menu.
